The word is out: "Get FIE's 44 coil!"

Our very own coil for the mag 44 not only yields MORE output, but is serviceable too. What could be better than more juice for less money in a repairable format?

MORE OUTPUT: The winding inside is our special recipe of copper wire (lots) and  laminations (big). It yields fantastic cranking spark, over 10% more voltage and more than a 10% increase in spark duration than the standard 8142 coil or the old original black version of the mag 44 coil. Voltage is what compels a spark to jump a gap and more voltage means this coil will fire in even more difficult conditions...higher compression ratio, more boost pressure, more fuel volume. More spark duration means the spark will last longer (more crankshaft degrees) to more thoroughly light your mixture. This coil will NOT work with Super-Mags. The winding is specifically formulated for MSD 20 and 44 mags. 

SERVICEABLE: Besides being a terrific dielectric medium to isolate every turn of copper wire, the special transformer oil inside also allows us to fix or repair the coil if anything happens to it. If ever needed, we can replace the entire winding, terminals, plastic pieces, etc. so you don't have to buy a new one. No more epoxy filled door stops!

AFFORDABLE: Our coil WITH the billet bracket is less initial cost than a new 8142. The repairable nature serves to enhance your initial investment for years to come.

These coils feature internal bolstering to prevent vibration and shake of the winding inside. We also use #10 stainless steel primary terminals and a brass high-tension output terminal on the bottom. Weight = 8 lbs. Bracket = 1.2 lbs.

Besides the positive (+) primary terminal, this coil has a SINGLE negative terminal (-) not two like the 8142. The winding grounds are joined together INSIDE the coil housing and two negative terminals are not needed. 

Available in either red or black (choose color option above). The price above INCLUDES a new billet aluminum bracket. The bracket comes assembled on your new coil ready to go. You can also use the option above to purchase without the bracket. Each coil comes with terminal nuts and #10 ring terminals for 10-12 GA wire.

MOUNTING: To make it easier to switch to our coil, the hole pattern for our bracket is now the same as the 8142 coil. It could be as simple as unbolting your old coil and bolting on ours!

After assembly here, each coil is load tested and measured for output in-house before packaging in a special re-usable box.

NOTE: This product is NOT manufactured by MSD, Inc.

 Click here to read/download the instruction sheet.

MADE IN USA